CTC Binary Protocol 5300 model

This document has only the specific information about the device connection settings and its address syntax.

Refer to the User Guide for more information on the Device Module.

Summary

CTC driver implements communication with controller compatibles with CTC Binary Protocol.

Supported Operands

Channels Configuration

Settings

Serial  channels:

Default configuration for RTU mode :

• DataBits: 8
• StopBits: 1 if parity is used, 2 if no parity

Set the other fields according to your Serial port configuration

TCP/IP channels:

• NodeConnections: Defines the maximum number of parallel requests that will be sent to each node (asynchronous communication)

Node Configuration

Station Configuration

TCP/IP channels:

• Station syntax: <IP address>

Where :

• <IP address>: IP address of the slave controller

                E.g.:  192.168.1.101 

Point Configuration

The syntax for the CTC communication points is: <Type><Number>

Where:

• <Type> indicates the memory area, the valid values are:
  •  R           for Register
  • AO         for Analog Output
  • AI          for Analog Input
  • F            for Flag
  • DI          for Digital Input
  • DO        for Digital Output

For more information about the valid types, see Supported Operands aforementioned.

• <Number> indicates the data address in the memory area, from 1 to 65535

E.g.: R10 (Type= Register, Number = 10)

Driver Revision History

In this section...