This document has only the specific information about the device connection settings and its address syntax.
Refer to the User Guide for more information on the Device Module.
This driver allows only to READ the channels, not write. The reason to have a read-only hardcoded driver to run on critical processes where the project should not be allowed to have a writing configuration option.
On this page:
Summary
NIDataSockes communication driver implements communication with National Instruments softwares, including LabView and others which are compatible with the National Instruments Data Sockes interface.
Communication Driver Information | |
|---|---|
Driver name | NIDataSocketsRead |
Assembly Name | T.ProtocolDriver.NIDataSocketsRead |
Assembly Version | 1.2 |
Available for Linux | False |
Devices supported | National Instruments Labview |
Manufacturer | |
Protocol | National Instruments Data Sockets |
Interface | TCP/IP |
Multi-threading | User defined |
Max number of nodes | User defined |
PC Requirements | Ethernet port |
NOTE
This driver supports any tag defined on target system.
Channels Configuration
Protocol Options
- Maximum size of blocks: Defines the maximum number of addresses in a read block.
- Message Format: defines the protocol used for the Data Sockets communication:
- DSTP
- OPC
- LOOKOUT
- HTTP
- FTP
Settings
TCP/IP:
- NodeConnections: Defines the maximum number of parallel requests that will be sent to each node (asynchronous communication)
Nodes Configuration
Station Configuration
TCP/IP:
Station syntax: <IP address>
Where :
- <IP address>: IP address of the slave device in the network
You can also add /<Branch> at the Station name.
E.g.: 192.168.1.1
122:168.1.1/MyTags
Points Configuration
The syntax for the communication point is: InitialBranch/TagList/Tag1
NOTE
Driver Revision History
NIDataSockets Revision History | |
|---|---|
Version | Notes |
1.2 | Initial release on new documentation standards. |